ANCHORING:
2 x Single bow rollers
Lorans Electric Windlass
1 x 45 1b CQR anchor
Extra anchor FX 23 Fortress with 3/8 chain & 5/8 rope
60m x 10mm galvanized chain
100' 5/8 rope spiced to chain
Customized bridal system for anchoring
6 x Fenders

DECK HARDWARE:
Lewmar main sheet system
Traveller control fitted on targa wing and accessible from cockpit
Main sheet ends at winch in front of double helm station
Lewmar adjustable genoa cars with stoppers
Spinlock or other jammers
Lewmar winches – 3 x 40 self-tailers
All blocks are Lewmar no 2 & 3
Main sheet and genoa can be easily trimmed from cockpit

ELECTRICS:
1 x 65 amp starter battery per engine
6 x Deep cycle batteries totaling 630 amps for house supply
1 x battery switch
1 x custom switch panel
1 x 12 volt outlet at switch panel
1 x AC outlet on switch panel
1 x AC outlet in galley
1 x AC outlet in each cabin
1 x AC outlet @ vanity port hull
Genset 5.0 Westerbeke
1 x Cruisair 16k BTU - saloon
1 x Cruisair 12k BTU - cabin
AC panel
2 x High voltage alternator 150 amps
1 x Galley fan
1 x Saloon fan
2 x Fan in each cabin
2 x 100w Solar panels
Link 2000 Xantrex

ELECTRONICS & NAVIGATION:
Raytheon wind, speed and depth and ST 5000 autopilot
Raytheon GPS, Chartplotter, Radar (Pathfinder)
Raymarine GPS
Icom VHF 402 with masthead aerial and Commander Microphone
1 Invertor Charger 2kva with all attachments for connecting to shore power
Front loader CD player with two speakers in saloon and 2 waterproof speakers mounted in targa wing
HF icom 802 with dyna plate and wire
T.V. antennae
EPIRB personal locator beacon
SAT Phone Iridium/Motorola
C-MAP chips for Raymarine Chartplotter and numerous paper charts

ENGINES:
Yanmar 30hp engines with saildrives and folding props
Wet muffler type exhausts with waterlocks
2 x Morse controls with engine control panels mounted in front of a double custom helmsman’s seat
Exhaust vents

HULL: (constructed to designer specification utilizing)
Resin approved by Lloyds, SABS and ISO 9002
Gelcoat approved by Lloyds, SABS and ISO 9002
A tissue layer is applied to the gelcoat throughout the entire boat to prevent osmosis
Lloyds approved 19mm Balsa Core used in sandwich construction vacuum bagged onto the glass layer
Chop strand mat 300g per square meter and stitched mat 640g per square meter approved by Lloyds SABS and ISO 9002
5 coats of International water proofing epoxy is applied over gelcoat below the waterline to add to the prevention of osmosis
International Antifowl is applied over this barrier
Deck specification are the same as the hulls and bridgedeck
All reinforcing

INTERIOR: (Owners version)
Headliners in saloon and all the cabins
2 x Queen size cabins with locker, hanging space and seating area
1 x ¾ size cabin with locker and hanging space fwd starboard
1 x Std head with locker and bathroom fittings starboard
1 x Custom head with locker and bathroom fittings fwd port
Built in cupboard with vanity section in port hull
Saloon wrap around seating for eight with upholstered cushion and storage below
Saloon table in beach
Galley extended 200mm to port to accommodate additional storage space
Smev 3 plate gas hob with under counter oven
70 lt logicold top loading freezer 12v
115 lt front loading fridge
Double sink with single swivel head tap with hot & cold water
Beech wood flooring
Berberpoint carpet on steps, wood flooring in hulls
Stipple painted finish with solid wood trim beech
Corian finished tops in galley, heads and cabins
Upright chart table
Wooden slat in main and secondary shower
Double shelves under bunks

LIGHTING:
1 x Down lights in each cabin
2 x Reading down lights in each cabin aft
1 x Fluorescent light in each head
1 x Fluorescent light in each engine room
1 x Fluorescent light in passage
1 x LED lights on each sugarscoop
6 x Down lights in saloon
1 x Cockpit light in targa wing walkway
2 x Lights in targa wing
2 x Reading lights in saloon
1 x LED light in each hull
1 x reading lamp Nav Station

MAST:
Standard Spar Craft anodized aluminium section with steaming, tricolour and deck light fitted with 2 Lewmar 30 ST winches and jammers
Standard Spar Craft anodized aluminium Boom section with vang
Standard profurl furler
Radar reflector
Antal System 40 (Battcars)

MISC. DECK FITTINGS:
6 x Cleats (2 x cleats on sugarscoops for Med. mooring)
2 x Trampolines
3 x Lockable winch handles
3 x Winch handle pockets
1 x Compass
Water and fuel filler fittings
Bimini fitted between coachroof and targa wing incorporating a solid walkway 1 x 520 Litre fuel tank with necessary return lines, breathers, etc
1 x 520 Litre water tank with all necessary return lines breathers, etc
14 x Portlights with trims & flyscreens
4 x Hatches with trims & flyscreens
1 x Fully anodized lockable sliding door
7 x 10mm Acrodyte windows
1 x Cockpit table
6 x Louver steps
4 x Exterior lockers
Full set of outside cushions - Sunbrella
Spinnaker bridle system
2 x Standup blocks spinnaker
35 Litre holding tank
Solid hatch
3 x vent hatch in each queen cabin

PLUMBING:
2 x electric toilets, large bowl
Fresh water pressure pump with accumulator tank
Mixers with shower outlets in both heads
Drain pumps with filters (upgrade to larger pumps)
20 lt Hot water clarifier for hot water system
Hot & Cold water rinsing shower mounted in sugar scoop or on the swim platform Mixing tap in galley with hot & cold water
1 x Rule 500 bilge pump in each hull with built in float switch
1 x Rule 500 bilge pump in each engine compartment with built in float switch Watermaker 35 lt tank
Deck wash pump x 2 outlet
Fixed on/off for drains
All valves centralized

RUNNING RIGGING:
12 mm Polyester braid main halyard
12 mm Polyester braid genoa halyard
12 mm Polyester braid main sheet
12 mm Polyester braid genoa sheets
12 mm Polyester braid spinnaker halyard
10 mm Polyester braid topping lift
10 mm Polyester braid roller furl line
12 mm Polyester braid outhaul
12 mm Polyester braid reefing lines x 2
10 mm Polyester braid traveler lines x 2

SAFETY EQUIPMENT:
3 x Fire extinguishers
Man overboard light
Horse shoe life ring
Dan buoy
8 x Life jackets
Capsize bottle with flares
4-Man Liferaft

SAILS:
Quantum crosscut mainsail with battens
Quantum radial genoa with foam UV protection
Stack pack
Down wind spinnaker with dowsing sock
More Sunbrella made by Quantum:
2 x Rope bags
Windlass cover
4 x Winch covers, throttle cover, compass cover
1 x Wheel cover
Gas BBQ cover
2 x Side flaps (exterior) mesh
2 x Side flaps (exterior)Sunbrella
Plastic/mesh front screen, window covers & back cockpit flap

STEERING:
Consists of a twin rudder system with stainless shafts connected by an adjustable stainless connection rod.
Delron bearings are used on the rudder shafts and the stainless steel arms are connected to the Whitlock steering system via stainless cable and a stainless chain.
The autopilot unit drives directly onto the connection rod.

STAINLESS STEEL:
2 x Stainless steel pulpits with seats
2 x Stainless steel pushpits
6 x Stainless steel stanchions
Double set of regulation size stanchion lines
Stanchion lines shackled to pulpits
Stanchion lines attached to pushpits with bottle screws
Handrails on coach roof
1 x fold up boarding ladder in sugar scoop
1 x Tender lift
2 x Chain plates
2 x Swim platform rails
1 x Grab rail at sliding door outside
1 x Grab rail at sliding door inside
2 x Solar panel brackets
2 x Skylight grab rails
Gas BBQ (Galleymate model #1500 Australian made) gas grill
Chafe plates

OTHER:
9.5' AB semi-rigid Dinghy with custom made cover - 2004
Honda 4-stroke 8 HP outboard - 2004