Manufacturer:

 Admiral Yachts

 Model:

 Admiral 50

 L.O.A.:

 50' 00"

 L.W.L.:

 45' 03"

 Beam:

 27'08"

 Draft Min/Max:

 4' 02"

 Bridgdeck Clearance:

 2' 06"

 Bridgedeck Length:

 31' 01"

 Engines:

 2 x Volvo 59hp Diesels with Saildrives

 Displacement:

 23,148 lbs.

 Mast Height From Water:

 68' 04"

 Mast height From Deck:

 57' 07"

 Berths:

 8

 Staterooms:

 4 x large double berths

 Heads:

 4 x heads with showers

 Fuel Capacity:

 211 gal.

 Fresh Water  Capacity:

 211 gal.

 Mainsail Area:

 861 sq.ft.

 Foresail Area:

 484 sq.ft.

 Spinnaker Area:

 925 sq.ft.

 Designer:

 Angelo Lavranos

• 3 x Single bow rollers

• Electric windless

• 1 x 65 Ib CQR anchor

• 100 x 10mm galvanized chain

• Custom bridal system for anchoring

• 6 x 16mm mooring warps

• 8 x Cylindrical fenders

• 1 X Fortress anchor with rope & chain

• Lewmar mainsheet system

• Main traveler control fitted on targa wing

• Mainsheet winch (Harken) in front of helm station

• Genoa tracks & cars

• Genoa & asymmetric winches in cockpit area (Harken)

• Spinlock jammers

• Various blocks & spare sheets

• 1 x 65 amp starter battery per engine

• 1 x Battery switch

• Custom switch panel

• 12volt outlet

• Watermaker 8 gal/hr

• AC panel

• 2 x 220 volt plug points in galley

• 1 x 220 volt plug point in each cabin

• 2 x 12 volt fans in galley

• 1 x 12 volt fan in each cabin

• 10 x voyager deep cycle batteries for house supply (total 1035 amps)

• Washer/Dryer

• Onan generator 8Kva

• Icemaker

• Raytheon wind, speed and depth

• Raytheon ST 7000 autopilot

• Raytheon chartplotter and radar (pathfinder)

• Icom HF radio 700

• Icom VHF radio 402 with exterior commander mic

• Radio with CD shuttle

• 2 x Interior speakers in saloon

• 2 x Exterior waterproof speakers

• Volvo 59hp marine diesel with saildrive and fresh water – cooling

• Wet muffler exhaust with waterlocks

• 1 x Exhaust vent in each engine compartment

• Morse control at helm station

• 2 x Delux instrument panels

• 2 x Flex-o-fold propellers

• Tops finished in Surrino

• 1 x 115 litre 12volt deep freezer

• Side panels in stippled paint finish with doors and trims in cherry

• 3 burner stainless steel gas hob with oven

• 1 x 150 litre 12volt fridge

• Double sink stainless

• Trash bin

• Weaver

• 12 x portlights with screens

• 2 x 500 x 500 saloon hatches for good ventilation

• 12 x Additional hatches in hull and forward cabins

• Resin approved by Lloyds, SABS and ISO 9002

• Gelcoat approved with Lloyds, SABS and ISO 9002

• A tissue layer is applied to the gelcoat throughout the entire boat to prevent osmosis.

• 5 – Coats of international water proofing epoxy is applied over gelcoat below the waterline to add to the prevention of osmosis

• International antifowl is applied over this barrier

• Lloyds approved 25mm balsa core used in sandwich construction vacuum bagged onto the glass layer

• Deck specifications are the same as the hulls and bridgedeck

• Stitched quad – axial glass is utilized in lay – up

• 1 x Chart table light

• 14 x Down lighters

• 1 x Florescent light in port and starboard hull

• 1 x LED courtesy light at stairwell of each hull

• 1 x Florescent light in each engine bay

• 1 x Florescent light in each head

• 2 x Down lighters in each cabin

• 2 x Reading lights in each cabin

• 1 x Cockpit light

• 4 x Down lights in targa wing

• 2 x LED courtesy boarding lights in sugarscoop

• Standard SparCraft aluminium section anodised with:

• Radar
• Deck Light
• Tri-Light
• 2 x winches Lewmar 42 and jammers

• Frederickson batt car system

• Radar reflector

• Boom anodised with stack pack and kicker strut

• Cross beam anodised with nav light and compression strut

• Roller Furler Unit

• 6 x Large aluminium cleats

• 2 x Trampolines

• 3 x Winch handles

• 3 x Winch pockets

• 1 x Compass

• Water and fuel fittings

• Water tanks

• Fully anodised sliding saloon door

• Fuel tanks

• 4 x Electric toilets, large bowl

• All taps in stainless with mixers

• Full pressurized hot and cold water system

• Large electric bulge pumps in hulls, engine compartments as well as in rudder compartments

• Cold water rinsing shower in transom

• 16mm Polyester braid main halyard

• 12mm Polyester braid topping lift

• 16mm Polyester braid genoa halyard

• 12mm Polyester braid roller furl line

• 16mm Polyester braid main sheet

• 16mm Polyester braid outhaul

• 16mm Polyester braid genoa sheet

• 16mm Polyester braid reefing lines x 2

• 16mm Polyester braid spinnaker halyard

• 12mm Polyester braid traveller line x 2

• Quantum Cross cut mainsail with battens

• Stackpack

• Quantum radial genoa with foam and UV protection

• 2 x Stainless pulpits with seats

• 2 x Stainless pushpits

• 1 x Port and starboard stainless gate

• Double set of regular lifelines

• Hand rails on coachroof

• 1 x Fold up boarding ladder

• 1 x Tender lift

• 2 x Chainplates

• 1 x Life ring holder

• 2 x Swim platform rails

• Consists of a twin rudder system with stainless shafts connected by an adjustable stainless connection rod

• Delron bearings are used on the rudder shafts and stainless steel arms are connected to the Whitlock steering system via stainless cable and a stainless chain